Took delivery yesterday, drove it from my trailer to the garage, everything was great. Parked it, took off the front clip, left it for about an hour. When I started it back up again the throttle pedal would not work. It moves for and aft, does not increase revs. Curious if this is an issue others have seen and fixed.
Chassis #303
- Thread starter VelvetFog45
- Start date
Just noting the response in the FB group here for reference - we have seen intermittent issues with throttle position sensors that are as easy to remedy as simply unclipped the harness from the pedal, plugging it back in, then restarting the car.
Thanks Sam - wasn't sure if Facebook was the right place to post issues like that, I suspect it's ok for the group. I tried that this morning, followed the directions explicitly, and to no avail. My AiM dash is listing an accelerator pedal figure of 148.6 so maybe this is electrical as you noted but not remedied by the harness itself. Will keep trying and report back. Appreciate the note.
Per my note on FB - the clip was fine but the wires going into the clip were not installed correctly. They just weren't pushed in and snapped. Fixed them. All good.
